The one-time Mac setup, step by step (Start Muxing)
Updated
Before Ecamm can talk to CommentMuxer, your Mac needs a one-time setup. One button does it.
Steps
- Open CommentMuxer and look at the Muxing panel. The Mac setup line in Status says "Not set up: Ecamm cannot reach this app yet".
- Press Start Muxing.
- The app works through three steps and checks each one before the next:
- Point the Twitch names at this Mac. macOS asks for your administrator password. See Why CommentMuxer asks for your administrator password.
- Trust the local certificate. macOS may ask for your password again.
- Confirm Ecamm can reach CommentMuxer. A final check, with nothing for you to do.
- When all three are done, the Mac setup line says "Ready: Twitch names point here and the certificate is trusted", and the button changes to Stop Muxing.
- If Ecamm was already open, quit and reopen it once.
A step that is already in place is skipped, so you can safely press the button again.
If a step fails
The step shows a note. Common ones:
- "Cancelled. Nothing was changed." You closed the password prompt. Press Start Muxing again.
- "The hosts file was not changed."
- "Cancelled. The certificate is not trusted."
- "macOS still does not trust the certificate."
- "The final check did not pass. Press Start Muxing to try again."
After a failure the button reads Try Again.
Prefer to do it yourself?
Open Settings, then Manual start/stop. It lists the same commands with Copy buttons, to run in Terminal.
If that didn't work
See The certificate is not trusted and Port 443 is already in use, or contact support.
Was this helpful?
Still need help? Contact support
Related articles
What do Start Muxing and Stop Muxing do?
Start Muxing makes the setup changes. Stop Muxing removes the hosts entry so Ecamm's Twitch connection goes back to normal.
How to undo the setup and uninstall CommentMuxer cleanly
Press Stop Muxing, remove the certificate if you wish, quit the app and drag it to the Trash.
Start Muxing was cancelled or failed, and Mac setup says "Not set up"
Press Start Muxing again and approve the macOS password prompts. Each step is checked, and finished steps are skipped.
Why does CommentMuxer ask for my Mac administrator password?
Changing the Mac's hosts file is a system change, so macOS itself asks for an administrator password. CommentMuxer never sees it.