"The certificate is not trusted" or setup fails at the certificate step
Updated
The app makes a small certificate on your Mac so Ecamm can trust its local secure connection. If macOS has not accepted it, the Mac setup line says "The certificate is not trusted yet".
Try this
- Press Start Muxing (or Try Again). Steps already done are skipped.
- When macOS shows its keychain prompt, enter your password and approve.
- Wait for the three steps to finish. The app checks for a short while after the prompt, because trust changes take a moment to reach new connections.
Messages and what they mean
- "Cancelled. The certificate is not trusted." You closed the prompt. Try again.
- "macOS still does not trust the certificate." The prompt was approved or skipped but macOS did not accept it.
- "The certificate could not be checked: the app did not answer on the Twitch names." The hosts entry or the app's listener is not working. See Port 443 is already in use.
Do it by hand
Open Settings, Manual start/stop. The first item is Trust the local certificate, with a command and a Copy button. Paste it into Terminal and enter your password when asked. Then press Recheck.
Check Keychain Access
The certificate lives in your login keychain, named CommentMuxer Local CA. If you have an old or duplicate one, delete it and press Start Muxing again.
Make sure you are an administrator
If your Mac account is not an administrator, macOS may refuse. See Why CommentMuxer asks for your administrator password.
Managed Macs
If your Mac is managed by an employer or school, trusting a new certificate may be blocked. We have not tested on managed Macs.
If that didn't work
Contact support with the message shown on the failed step.
Was this helpful?
Still need help? Contact support
Related articles
Ecamm can't connect to the Twitch destination, or Go Live fails
Check that CommentMuxer is running and Muxing is on, reopen Ecamm, and sign in to Twitch in Ecamm again if asked.
Start Muxing was cancelled or failed, and Mac setup says "Not set up"
Press Start Muxing again and approve the macOS password prompts. Each step is checked, and finished steps are skipped.
"This Mac was disconnected": CommentMuxer says my account is in use elsewhere
Your licence was taken by another Mac, or released on the website. Press Sign in to use this Mac again, which will disconnect the other one.
CommentMuxer says "No internet" and is locked
The app cannot reach the internet, so it locks until it can. It checks again every few seconds and unlocks by itself.