Start Muxing was cancelled or failed, and Mac setup says "Not set up"
Updated
The Mac setup line says "Not set up: Ecamm cannot reach this app yet" until the three setup steps pass.
Steps
- Press Start Muxing, or Try Again if the last attempt failed.
- Approve the macOS prompts.
- Read the list of steps that appears. A step that failed shows its reason after a dash.
What each failure means
- Point the Twitch names at this Mac
- "Cancelled. Nothing was changed." You closed the password prompt.
- "The hosts file was not changed." macOS did not apply the change. Try again with an administrator account.
- "The app is listening on port (a number); Ecamm can only reach port 443." See Port 443 is already in use.
- Trust the local certificate. See The certificate is not trusted.
- Confirm Ecamm can reach CommentMuxer. "The final check did not pass. Press Start Muxing to try again."
Do it by hand
Open Settings, Manual start/stop, and use the Copy buttons.
Press Recheck
After a manual change, press Recheck in Status.
Partially done
If the hosts line is in place but the certificate is not, the note says: "Twitch's names point here, but the certificate is not confirmed yet." Press Start Muxing again to finish.
If that didn't work
Contact support with the failed step and its message.
Was this helpful?
Still need help? Contact support
Related articles
"The certificate is not trusted" or setup fails at the certificate step
macOS has not accepted the app's local certificate. Press Start Muxing again and approve the macOS prompt, or run the trust command from Settings.
"This Mac was disconnected": CommentMuxer says my account is in use elsewhere
Your licence was taken by another Mac, or released on the website. Press Sign in to use this Mac again, which will disconnect the other one.
CommentMuxer says "No internet" and is locked
The app cannot reach the internet, so it locks until it can. It checks again every few seconds and unlocks by itself.
Port 443 is already in use, or the app says "A port is already in use"
Another copy of CommentMuxer, or another program, is holding the secure web port the app needs. Quit it and reopen CommentMuxer.