How to put a viewer's comment on screen in Ecamm

Updated

Showing a comment on screen is an Ecamm Live feature. CommentMuxer's job is to get the comment into Ecamm. After that you use Ecamm exactly as you would with any comment.

Steps

  1. Make sure comments are reaching Ecamm's Comments & Reactions window. See Where do I see the comments in Ecamm Live?
  2. Use Ecamm's comment overlay controls to show the comment you want on screen. The viewer's name and picture come with it.
  3. Hide it again with the same controls when you are done.

The steps for the overlay itself are in Ecamm's own help, because they depend on your Ecamm version.

Show a comment again

If you want a comment to appear again, for example one you showed earlier, use Push in CommentMuxer. It sends the comment to Ecamm again as a new message, so Ecamm shows it again. See Use the Comments panel.

Plan ahead with a test

Before the show, send a test comment from the Manual comment panel and practise showing it. You can choose a name and picture for it. See Test with a manual comment.

Remember

  • During a free trial, a short promotional comment appears in Ecamm every few minutes. If you put comments on screen, your audience may see it too. See Promotional comments during the free trial.
  • A banned viewer's comments never reach Ecamm.

If that didn't work

If comments reach CommentMuxer but not Ecamm, see Comments are not appearing in Ecamm.

Was this helpful?

Still need help? Contact support

Related articles

Back to support